| [ VG-876/VG-877 Firmware Download ] |
|
|
|
[ Procedure ]
|
|
| If the current version is 1.80 or older, please follow the following instructions. |
| 1. |
Download the data of "Firmware for older version users".
Save "VG-876v××××.bin" and "VG-876v××××.txt" file in the USB memory.
(×××× is different from version number.) |
| 2. |
Insert USB memory to the VG unit, Press [ESC] key and power ON. |
| 3. |
When the display shows "End, Please reboot,", please turn off power. |
| 4. |
Then, continue the below procedure "if the current version is Ver1.90 or later...". |
|
|
|
If the current version is Ver1.90 or later, please start from here.
|
|
1.
|
Save all files directly under the USB flash. Please do not save as folder, but save as "files".
|
| 2. |
Insert USB memory to the VG unit. Press [ESC] key and power ON. |
| 3. |
Version up starts automatically.
You will see the message “FPGA/Firmware Version Up” on front display. |
| 4. |
When the display shows “End. Please reboot!!”, turn off power. |
| 5. |
Keep the USB memory inserting VG main unit.
Press [MENU], [SHIFT] and [ESC] keys and power ON. |
| 6. |
Version up starts automatically.
You will see the message “FPGA/Firmware Version Up” on front display. |
| 7. |
When the display shows “End. Please reboot!!”, turn off power. |
| 8. |
Repeat 5 to 7 again. |
|
|
|
|
[ Note : ]
|
|
|
1. When you change VM interface unit, please perform above version up.
2. Do not turn off power during version up. Otherwise, it will damage the internal data
|
|
